AMX Modero ViewPoint MVP-8400i Operation/Reference Manual page 36

Configuring Communications
4. Press the red SSID field to display the on-screen Network Name (SSID) keyboard.
5. In this keyboard, enter the SSID name used on your target Wireless Access Point (case sensitive).


6. Click Done when you've completed typing in the information.
7. From the Wireless Security: Simple Mode window, press the Save button to incorporate your new
information into the panel and begin the communication process.
8. Verify the fields in the IP Settings section have been properly configured. Refer to Step 1: Configure
the Panel's Wireless IP Settings section on page 15 for detailed information.
9. Press the Back button to return to the Protected Setup page and press the on-screen Reboot button
to both save any changes and restart the panel. Remember that you will need to navigate to the
System Settings page and configure the connection to a target Master.
10. After the panel restarts, return to the Wireless Settings page's Information/Configuration section and
verify the Signal Level Value and the Signal Level:

The signal strength field should provide some descriptive text regarding the strength
of the connection to a Wireless Access Point. If there is no signal or no IP Address
displayed; configuration of your network could be required.
22
The card should be given the SSID used by the target WAP. If this field is left blank, the unit
will attempt to connect to the first available WAP. By default, all WAP200Gs use AMX as
their assigned SSID value.
One of the most common problems associated with connection to a WAP arise because the
SSID was not entered properly. You must maintain the same case when entering the SSID
information. ABC is not the same as Abc.
The Signal Level is displayed as a bar graph.
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom