Jumper Settings For Cmos Clear; Cpu Installation - DFI 586STE User Manual

Jumper Settings for CMOS Clear

Jumper JP13
CMOS Clear Select
If, for some reason, the CMOS becomes corrupted, the system can be
reconfigured with the default values stored in the ROM BIOS. To load
the default values, power off your system and set JP13 pins 2 and 3 to
On. Power on your system. After you boot up an operating system, turn
your system off again. Set JP13 back to its default setting, pins 1 and 2
On.
1
2
3
1-2 On: Normal
(default)

CPU Installation

The 586STE allows for easy installation of CPUs. Make sure all jumpers are
set correctly before applying power or you may damage the CPU or system
board. Use a needle-nosed plier to move the jumpers if necessary.
Jumpers JP4, JP9, JP10 and JP11 are used to set the external bus clock of
your processor. Refer to the following pages for the external bus clock that
corresponds to your processor and set these jumpers accordingly. The
clock generator will determine the external bus clock that must be sent to
the processor through these settings.
Jumpers JP1 and JP2 are used to set the frequency ratio of your processor.
Refer to the following pages for the frequency ratio that corresponds to your
processor and set these jumpers accordingly.
1
2
3
2-3 On: CMOS Clear
17