Using The Dmi Utility - DFI 586STE User Manual

The DMI utility must run in real mode with at least 180K of base
memory. Memory managers like HIMEM.SYS (required by Windows)
must not be installed. To do this, boot up from a system diskette without
the AUTOEXEC.BAT and CONFIG.SYS files. " REM" HIMEM.SYS in the
CONFIG.SYS or press <F5> during bootup to bypass your
AUTOEXEC.BAT and CONFIG.SYS files.

Using the DMI Utility

Award DMI Configuration Utility Copyright Award Software Inc, 1996
[Edit DMI] [Add DMI] [Load DMI File] [Save DMI File]
s BIOS
n
System
Enclosure/Chassis
Processor
Memory Controller
Memory Module
Memory Module
Memory Module
Memory Module
Cache
Cache
Port Connector
Port Connector
Port Connector
Port Connector
Port Connector
Port Connector
Port Connector
System Slots
↑ ↓ ← →
Move cursor ENTER-Accept DEL-Delete ESC-Abort&Exit
The four menus located on top of the DMI Configuration Utility screen
are Edit DMI, Add DMI, Load DMI File and Save DMI File. Use the ←
or → (left or right) arrow keys to select a menu from the Menu bar.
On the left side of the screen is a list of the system configuration items.
Use the ↑ or ↓ (up or down) arrow keys to select an item. The com-
mands at the bottom of the screen will allow you to navigate through
the various setup menus.
Edit DMI
1. Use the ← or → arrow keys to select the Edit DMI menu.
2. Highlight the item on the left screen that you would like to edit by
using the ↑ or ↓ arrow keys, then press <Enter>.
3. The cursor will move to the screen you select allowing you to edit
information. The screen will also display the auto-detected informa-
tion.
54
*** BIOS Auto Detect ***
Type : BIOS Information
Handle : 0000
Vendor Name : Award Software International, Inc.
BIOS Version : 4.51PG
BIOS Starting Address Segment : E000
BIOS Build Date :
BIOS Characteristics : Press [ENTER] for details
Size of BIOS ROM : 0128K