Seat Height; Arm Width Adjustment - Shoprider Paris GK9 User Manual

Continued.....
Seat Post
Fig 4
Seat Height Adjustment (Fig. 4)
Remove the seat as previously described
and remove the battery pack (see page 11).
Use two 13mm spanners and undo the
locking bolt and nut. Adjust the seat post up
or down to the desired height and relocate
the locking bolt through the hole and replace
the washer and nut and re-tighten. Replace
the battery and the seat. The higher the
seat is adjusted; stability may be affected Locking Bolt
due to the higher centre of gravity.
IMPORTANT: Your seat height is set in the lowest position for shipping
purposes. In this position the seat must be removed to allow the battery
pack to be removed.
Arm Adjustments (Fig. 5)
Fig 5
On each side of the seat towards the back
Armrest Angle Adjustment Bolt
there are two hand knobs. These are to
adjust the width of the armrests or to remove
then for transport.
Turn the knobs anti-clockwise to loosen.
Once the knobs are loose you will be able to
adjust the armrests in or out to the desired
width. Re-tighten when a comfortable width
has been achieved or remove the armrests
completely for transport.
Armrest Height Adjustment
To adjust the angle of the armrest, unscrew
the main bolt until the desired the angle is achieved. Lock the bolt in place
with the locking nut.
To adjust the height of the armrest, undo the handknob until the armrest can
be raised / lowered. Once the required height is achieved refit the handknob,
ensuring the pin locates fully in the hole in the armrest tube.
If removing the armrests for transport, ensure that the knobs are re-
tightened to avoid them rattling loose and falling out.
Do not apply full body weight to the armrests for transferring. Pivot the
seat or lift the arm up out of the way to transfer to another seat.
7