Circuit Breaker; Fuses; Check List - Shoprider Paris GK9 User Manual

Continued.....
We also recommend that the connectors between the battery pack and the
main chassis are also treated at the same time to prevent any carbon build up
(round plate connectors and pins). Simply re-assemble the scooter as per
user manual after these procedures have been undertaken.
Note: Should any part of your scooter need replacing or repairing please
contact your local dealer to undertake any maintenance. Failure to do
this may void your Warranty.
Troubleshooting

Circuit Breaker

Your scooter is fitted with the latest in electronic controls that are programmed
to protect the electrical system from abnormal overloads. Fitted for extra
protection is a circuit breaker, which is located on the battery pack (Fig. 11).
Should there be a situation where your scooter stops for no apparent reason
please check that the circuit breaker has not tripped. Simply press the button
to reset the circuit breaker.
Note: Should the circuit breaker continue to trip turn off the scooter
immediately and consult your dealer.

Fuses

There are two 40 amp blade type fuses inside the battery pack to give
protection against possible overload on the wiring.
Caution! Do not attempt to open the battery pack to replace the fuses.
Please take the battery pack to an authorised dealer to replace any
blown fuses.

Check List

If your scooter fails to operate, please check the following:
 The unit is switched on.
 All plugs and connections are firmly fixed.
 Battery level shows full charge.
 Freewheeling device is in the drive position (See Fig. 8).
 Circuit breaker has not tripped.
 Contacts between front and rear chassis are dirty.
If the freewheel device has been operated with the scooter switched on, the
scooter will not operate until the key switch has been turned off and on again.
Note: Should your scooter fail to operate after checking these possible
problems, consult your local dealer immediately.
15