Seat Height Adjustment; Arm Adjustment - Shoprider Valencia User Manual

Seat Height Adjustment

Remove the seat as previously described
battery pack Undo the securing screw with an allen key
and use two 13mm spanners and undo the locking bolt
and nut.
Adjust the seat post up or down to the desired height
and relocate the locking bolt through the hole and replace
the washer and nut and re-tighten. Replace the battery
and the seat.
Note:
The higher the seat is adjusted; stability may be affected due to the higher centre of gravity.
Note:
Your seat height is set in the lowest position for shipping purposes. In this position the seat
must be removed to allow the battery pack to be removed.
Arm Adjustments
On each side of the seat towards the back there are two
hand knobs. These are to adjust the width of the armrests
or to remove then for transport.
Turn the knobs anti-clockwise to loosen. Once the knobs
are loose you will be able to adjust the armrests in or out
to the desired width. Re-tighten when a comfortable width
has been achieved or remove the armrests completely for
transport.
To adjust the angle of the armrest, unscrew the main
bolt until the desired the angle is achieved. Lock the bolt
in place with the locking nut. To adjust the height of the
armrest, undo the handknob until the armrest can be
raised / lowered. Once the required height is achieved refit
the handknob, ensuring the pin locates fully in the hole in
the armrest tube.
Note:
If removing the armrests for transport, ensure that the knobs are re- tightened to avoid
them rattling loose and falling out. Do not apply full body weight to the armrests for
transferring. Pivot the seat or lift the arm up out of the way to transfer to another seat.
and remove the
7