AutoDome 600 Series Analog PTZ Camera
2.10
Attach Pendant to Arm and Tighten
NOTICE!
Before attaching the AutoDome Pendant, visually inspect the dome and arm connectors for
any blocked pin holes or bent pins.
1.
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
Tilt the bottom of the dome toward the pendant arm base and place the mounting hook,
located on top of the dome housing, over the recessed hinge pin of the arm.
Figure 2.17 Attach Pendant to Arm
1
Tilt up.
2
Hook and drop.
2a Recessed Hinge Pin
2b Dome Connector
3
Rotate down to engage dome connector.
4
Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m
(90-105 in.-lbs).
Installation Manual
a
b
F.01U.215.782 | 1.0 | 2011.04
35