Bosch AutoDome 600 Series Installation Manual page 63

AutoDome 600 Series Analog PTZ Camera
4.
5.
6.
7.
8.
9.
Bosch Security Systems, Inc.
Route the coaxial cable with ferrite, which shipped with the AutoDome, inside the
Interface Box as shown:
Attach a BNC connector to the incoming video coax cable. Connect the incoming coax
cable to the BNC jack (female connector enclosed by the plastic cover) on the coax cable
with ferrite. Slide the plastic cover over the connection. Refer to Section 4.6.1 Coaxial
Cable Connections, page 62.
Connect the BNC plug (male connector) of the coax cable with ferrite to its mating
connector J102 in the Interface Box.
Attach the video and control data in/out wires to their respective terminals in the
Interface Box. Refer to Table 4.1, Page 66, for terminal connections.
If using UTP for video, you must attach an RJ45 connector plug to the incoming UTP cable
and connect it to its matting connector J101 in the Interface Box. Refer to
Section 5 Cable and Wire Standards, page 70 for specifications.
Note: Do not connect the RJ45 connector unless using UTP video.
Connect the 24 VAC power wires to the P101 connector in the Interface Box.
Installation Manual
Installing the In-Ceiling Mount | en
F.01U.215.782 | 1.0 | 2011.04
63