Mount Power Supply Box - Bosch AutoDome 600 Series Installation Manual

AutoDome 600 Series Analog PTZ Camera
3.3

Mount Power Supply Box

Before mounting the Power Supply Box decide if you will be wiring the box through the holes
in the bottom or back of the box. If wiring the box through the back, move the two (2) seal
plugs to the bottom holes before mounting.
NOTICE!
Use 3/4-inch NPS (20-mm) fittings for the holes on the bottom and back of the box. Use 1/2-
inch NPS (15-mm) fittings for the side holes. Refer to Section 3.1.1 Parts List, page 37, for an
illustration.
Figure 3.1 Wall Mount Power Supply with Optional Trim Skirt
1.
2.
3.
4.
NOTICE!
A stud diameter of 6.4 mm (1/4 in.) or 8 mm (5/16 in.), able to withstand a 120 kg (265 lb)
pull-out force is recommended.
5.
Bosch Security Systems, Inc.
Use the wall mount template supplied in the packaging box to locate the four (4)
mounting holes for the Power Supply Box.
Drill four (4) holes for the mounting anchors. If installing outdoors, apply a weatherproof
sealant around each hole at the mounting surface.
Place the Power Supply Box into the optional Trim Skirt.
Secure the Power Supply Box to the wall using four (4) corrosion-resistant stainless steel
studs (not included).
Attach the 3/4 in. (20 mm) watertight pipe fittings (not supplied) to the holes of the
Power Supply Box through which you will run the power, video, and control data wires.
Installation Manual
Installing Roof Parapet and Pipe Mounts | en
F.01U.215.782 | 1.0 | 2011.04
39