AutoDome 600 Series Analog PTZ Camera
2.4.1
Coaxial Cable Connections
If you are using coaxial cable to connect an AutoDome to a head-end system, you must use the
coaxial cable with ferrite included in the AutoDome packaging. The following illustration
shows the components of this cable:
Figure 2.2 Coaxial cable with ferrite
1
2
3
4
You must connect the incoming coax cable (from the head-end) to the BNC jack (item 4
above) on the ferrite cable and connect the BNC plug (item 1) of the ferrite cable to the BNC
connector from the AutoDome pendant arm.
2.4.2
Make the Connections
Figure 2.3 Pendant Arm Power Supply Box
Bosch Security Systems, Inc.
BNC Plug (male connector)
Ferrite
Plastic cover
BNC Jack (female connector)
P101
24V
NC
24V
P106
GND T XD R XD
C+ C-
GND T XD R XD
Installation Manual
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
J102
24 VAC
(LED)
P105
C+ C-
17
F.01U.215.782 | 1.0 | 2011.04