Attach Housing To The Interface Box - Bosch Autodome Inteox 7000i-2MP Installation Manual

20 en | Installing the In-Ceiling Mount
7.6

Attach Housing to the Interface Box

The In-Ceiling Housing is attached to the Interface Box and secured by two (2) thumbscrews.
Figure 7.3: Attach Housing to Interface Box
1.
2.
3.
Figure 7.4: In-Ceiling Housing and Interface Box
1
2
3
2021-08 | 1.4 |
Insert the In-ceiling housing through the hole in the ceiling to verify that the edge of the
hole support the unit. Then remove the housing from the hole.
Align the ball studs of the In-Ceiling Housing to the Stud Retainers on Interface Box and
attach.
Tighten the two (2) Thumbscrews to secure the Interface Box to the housing.
Interface Box
Ball Stud
In-ceiling Housing
4
5
6
Installation Manual
AUTODOME inteox 7000i - 2MP (in-ceiling)
Thumb Screw
Tether Point
Ceiling Clamp
Bosch Security Systems