Bosch AutoDome 600 Series Installation Manual page 34

34 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
5.
6.
7.
8.
F.01U.215.782 | 1.0 | 2011.04
Rotate the Bubble Assembly counterclockwise approximately 20 degrees until the bubble
assembly releases from the Pendant Housing.
Figure 2.16 Pendant Bubble Release Opening
Remove the foam inserts surrounding the camera module.
If you plan to use the RS232 or the RS485 protocol to control the dome, refer to either
Section 5.4.2 Controlling the AutoDome via the RS232 Protocol, page 74, or
Section 5.4.3 Controlling the AutoDome via the RS485 Protocol, page 75, for instructions.
Then, proceed to the next step.
Re-insert the Bubble assembly into the Pendant housing, and rotate it clockwise (looking
down at the dome) until it locks. The latch mechanism makes a click when it locks.
Installation Manual
AutoDome 600 Series Analog PTZ Camera
Bosch Security Systems, Inc.