Attach Pendant To Arm And Tighten - Bosch AutoDome 700 Series Installation Manual

28 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
2.9

Attach Pendant to Arm and Tighten

NOTICE!
Before attaching the AutoDome Pendant, visually inspect the dome and arm connectors for
any blocked pin holes or bent pins.
1.
2.
F.01U.215.779 | 1.0 | 2011.07
Tilt the bottom of the dome toward the pendant arm base and place the mounting hook,
located on top of the dome housing, over the recessed hinge pin of the arm.
Figure 2.14 Attach Pendant to Arm
1 Tilt up.
2 Hook and drop.
2a Recessed Hinge Pin
2b Dome Connector
3 Rotate down to engage dome connector.
4 Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m
(90-105 in.-lbs).
Drop the dome housing down slightly to engage the dome housing hook on the Pendant
Arm hinge pin, allowing the dome to rotate around the pin.
Installation Manual
AutoDome 700 Series IP PTZ Camera
a
b
Bosch Security Systems, Inc.