Bosch AutoDome 600 Series Installation Manual page 48

48 en | Installing Roof Parapet and Pipe Mounts
2.
NOTICE! Fasteners are not supplied with the Roof Parapet Mount Kit since it depends on the
material to which it is attached. The material must accommodate a minimum pull out strength
of 275 kg (600 lbs). For example, 19 mm (3/4 inch) minimum for plywood. Fasteners can
include bolts, studs, or lag bolts. All fasteners must be made of corrosion-resistant stainless
steel, with a diameter of 10 mm (3/8 inch).
All bolts must fully extend through the mounting surface and be secured with a flat washer,
lock washer and a nut. All studs must be anchored to concrete or welded to a steel backing
plate. Anchor bolts can be used for blind structures where there is no access to the rear.
3.
4.
5.
F.01U.215.782 | 1.0 | 2011.04
Prepare the mounting surface for the type of fastener by drilling holes for the mounting
anchors as required.
Figure 3.7 Parapet Wall Mount Bracket and Roof Mount Plate
1 Pipearm
2 Parapet Wall Bracket
3 3/8-16 SS Hex Head Bolt (supplied) 6 Use a minimum of six (6) fasteners (not
Apply a weatherproof sealant around each fastener hole at the mounting surface.
Attach the Parapet Wall Bracket using at least six (6) stainless steel fasteners, three (3)
on each side (the bracket has eight (8) holes). Be careful not to over tighten the
fasteners because it may strip the threads. If attaching the parapet mount to a flat roof,
attach the optional LTC 9230/01 Roof Mount Plate to the roof and then attach the
Parapet Wall Bracket to the Roof Mount Plate.
Insert the Parapet Pipe Arm into the mounting bracket until it bottoms in the bracket.
Installation Manual
AutoDome 600 Series Analog PTZ Camera
4 Apply sealant around each fastener hole
5 Roof Mount Plate
supplied). Eight (8) fastener holes shown.
Bosch Security Systems, Inc.