Prepare Bubble - Bosch AutoDome 600 Series Installation Manual

66 en | Installing the In-Ceiling Mount
The following table summarizes the pin connectors and their function:
No.
P103 Alarms In
P102 Alarms Out
P104 Analog Relay
P105 Data In/Out
P101 24 VAC
J102
J101
Table 4.1 Interface Box Wire Terminals
WARNING!
24 VAC Class 2 power supply only.
4.7

Prepare Bubble

The inside of the housing contains packing material to safeguard the camera during shipping.
You must remove the packing material before attaching the in-ceiling housing to the interface
box.
To remove the Bubble:
1.
2.
3.
4.
5.
F.01U.215.782 | 1.0 | 2011.04
Connector Pin 1
Alarm 3
Alarm 1
Relay
N.O.
C-
(BiPhase)
Line
Video BNC Connector Input
UTP/Ethernt Connector Input
(Ethernet for VG5
700 Series only)
Loosen the lockscrew (item 1 in the illustration below) in the trim ring using a P1 or
smaller Phillips screwdriver until the bubble can rotate freely.
Then rotate the bubble counterclockwise approximately 1/4 turn until it releases from
the In-Ceiling Housing. See the figure below for an illustration.
Figure 4.10 Bubble Release Screw
Remove the foam inserts surrounding the camera module.
If you plan to use the RS232 or the RS485 protocol to control the dome, refer to either
Section 5.4.2 Controlling the AutoDome via the RS232 Protocol, page 74, or
Section 5.4.3 Controlling the AutoDome via the RS485 Protocol, page 75, for instructions.
Then, proceed to the next step.
Place the bubble over the Camera Module, and align it until it settles.
Installation Manual
AutoDome 600 Series Analog PTZ Camera
Pin 2 Pin 3 Pin 4
Alarm 4 Alarm 5 Alarm 6
Alarm 2 Alarm 3 GND
Relay Relay Earth
COM N.C.
C+ Earth RXD (+)
(BiPhase) Ground (RS-232/485)
Earth Neutral
Pin 5 Pin 6 Pin 7
Alarm 7 AGND
Alarm 1 Alarm 2 Ground
TXD (-) Signal
(RS-232/485) Ground
Bosch Security Systems, Inc.