Bosch AutoDome 600 Series Installation Manual page 53

AutoDome 600 Series Analog PTZ Camera
3.
WARNING!
Do not connect the RJ45 connector unless using UTP video. This connection causes video
distortion.
4.
5.
CAUTION!
To protect the AutoDome from damage due to cold temperatures, ensure that you connect the
24 VAC heater power wires to the P101 connector.
6.
Figure 3.12 Alarm and Relay Connector Plugs
1
Pin Description
1
2
3
4
7.
Bosch Security Systems, Inc.
If using UTP for video, attach an RJ45 connector plug to the UTP cable and connect the
plug to its mating connector J101 on the Pipe Interface Board.
Attach the control data in/out wires to their respective terminals on the P105 connector
on the Pipe Interface Board. Refer to Figure 3.11, Page 51, for an illustration of these
connections.
Connect the 24 VAC power wires to the P101 connector on the Pipe Interface Board. If
this model has a heater, connect the 24 VAC heater power wires to connector P107.
To connect alarm inputs and outputs, attach the supplied 6-pin Alarms In and the 4-pin
Alarms Out connector plugs with flying leads to the appropriate alarm wires. Then
connect the plugs to their mating connectors P103 and P102 on the Pipe Interface Board.
PIN
1
2
3
4
PIN
1
2
3
4
5
6
4-pin Alarm Connector 2
(P102)
Pin Description
Alarm Out 1 1
Alarm Out 2 2
Alarm Out 3‡ 3
Alarm Ground 4
5
6
To connect supervised alarms and relays, attach the appropriate wires to their terminals
on the P104 connector on the Pipe Interface Board (see Figure 3.12, above). In addition,
refer to Section 6 Alarms and Relay Connections, page 79 for more details on wiring alarms
and relays.
Note: There is a slot located at the top of the Interface Board to tie the wires to the
circuit board with a cable tie.
Installation Manual
Installing Roof Parapet and Pipe Mounts | en
WHITE
BROWN
P102
ORANGE
GREEN
WHITE
BROWN
ORANGE
P103
GREEN
YELLOW
BLUE
6-pin Alarm In Connector
(P103)
Alarm In 3
Alarm In 4
Alarm In 5
Alarm In 6
Alarm In 7
Alarm Ground
1
2
3
4
5
6
7
P104
3 7-pin Relay Connector
(P104)
Pin Description
1 Alarm Out 4 Normally Open
2 Alarm Out 4 COM
3 Alarm Out 4 Normally Closed
4 Earth Ground
5 Analog Alarm 1
6 Analog Alarm 2
7 Ground
F.01U.215.782 | 1.0 | 2011.04
53