Bosch AutoDome 600 Series Installation Manual page 78

78 en | Cable and Wire Standards
10. Ensure that the VG5 AutoDome is set to receive RS232 commands.
11. Return the bubble to the AutoDome housing.
12. Return power to the power supply box.
F.01U.215.782 | 1.0 | 2011.04
– Remove the bubble from the VG5 AutoDome housing.
– Locate the protocol switch on the CPU board.
– Ensure that the protocol switch is in the left position for RS232 operation.
Figure 5.9 Position of CPU Switch for RS232 Operation
1 Switch Location
2 LEDs
3 Move Switch to the left for RS232 Operation
4 CPU Module
Installation Manual
AutoDome 600 Series Analog PTZ Camera
Bosch Security Systems, Inc.