Attach Pendant To Arm And Tighten - Bosch VG5 600 Series Installation Manual

34 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
2.10

Attach Pendant to Arm and Tighten

NOTICE!
Before attaching the AutoDome Pendant, visually inspect the dome and arm connectors for
any blocked pin holes or bent pins.
1.
1
2
2a Recessed Hinge Pin
2b Dome Connector
3
4
F.01U.265.793 | 2.0 | 2012.02
Tilt the bottom of the dome toward the pendant arm base and place the mounting hook,
located on top of the dome housing, over the recessed hinge pin of the arm.
Figure 2.16 Attach Pendant to Arm
Tilt up.
Hook and drop.
Rotate down to engage dome connector.
Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs).
Installation Manual
AutoDome 600 Series Analog PTZ Camera
a
b
Bosch Security Systems, Inc.