Table of Contents
Advertisement
General Installation Process
The installation instructions in this section are for general components of Intel® Server System
P4000SC family, but the illustrations are based on the Intel® Server System P4308SC2MHGC.
Minimum Hardware Requirements
To avoid integration difficulties and possible damage to your system,
make sure you have components from each category below.
Processor
I
Heat Sink
I
Memory
I
Hard Disk Drives
I
Power
I
Air Duct
I
2
Remove the Side Cover
A
Remove the screws.
B
Slide the side cover back and lift
the cover outward to remove it.
NOTE:
A non-skid surface or a
stop behind the chassis
may be needed to prevent
the chassis from sliding on
your work surface.
4
Remove Processor Heatsink(s)
CAUTION: The heatsink has thermal interface material (TIM) on
the underside of it. Use caution so that you do not damage the
thermal interface material. Use gloves to avoid sharp edges.
The heatsink is attached to the server
board/processor socket with captive fasteners.
Using a #2 Phillips* screwdriver, loosen the four
screws located on the heatsink corners in a
diagonal manner using the following procedure:
A
Using a #2 Phillips* screwdriver,
start with screw 1 and loosen it
by giving it two rotations and stop.
(IMPORTANT: Do not fully loosen.)
B
Proceed to screw 2 and loosen it by
giving it two rotations and stop.
Similarly, loosen screws 3 and 4.
Repeat steps A and B by giving each
screw two rotations each time until
all screws are loosened.
C
Lift the heatsink straight up.
A
A
A
3
C
2
4
1
Preparing the System
Observe normal ESD (Electrostatic Discharge) procedures.
Place your Intel
®
Server System on a flat anti-static
surface to perform the following integration procedures.
Observe ESD procedures before reaching inside to make
server board connections or install components.
3
A
A
B
5
Install the Processor(s)
CAUTION:
1. When opening a socket,
DO NOT TOUCH the gold
socket wires.
2. When unpacking a processor,
hold by the edges only to
avoid touching the gold
contact wires.
1
B
3
Remove the Air Duct
Remove the air duct.
A. Open the Socket Lever
A
Push the lever handle down
and away from the socket to
release it.
B
Rotate the lever open all
the way.
B
A
Advertisement
Table of Contents
