Table of Contents
Advertisement
General Installation Process
14
Install Intel® RAID Smart Battery (optional)
A
Align the tabs on the plastic
battery holder with the
mounting holes in the chassis
and slide the plastic battery
holder toward the front of the
chassis until the tabs engage
with the mounting holes.
15
Install Second Power Supply Module (optional)
NOTE: Applies only to the chassis with hot-swap power supply configuration.
Finger
Hole
A
A
Use the 'finger hole' to remove the
filler panel.
16
Rack Mount Configuration
(optional)
• If you intend to configure your server as a pedestal
system, disregard this step.
• If you intend to configure your server as a rack mount
system, follow the instructions that come with your Rack
Mount Kit to complete your server assembly.
®
NOTE: Only Intel
Server System P4308SC2MHGC
supports rack mount configuration.
For P4304SC2SFEN & P4304SC2SHDR
A
r
S e r v e
B o a r d
B
B
Insert the power supply module into the power
supply cage and push all the way until it clicks
into place.
17
Install Feet (pedestal only)
NOTE: This step applies to your chassis if configured as a pedestal system. If
you plan to configure your chassis as a rack-mount system, disregard this step.
A
B
NOTE: Repeat
above steps until
all four feet are
installed.
10
For P4308SC2MHGC
A
Latch
Handle
To remove a power supply module, push the
green latch in the direction shown and pull
out of the system by the handle.
Insert rubber foot into chassis hole.
Secure foot by inserting pin through the rubber foot.
B
A
Advertisement
Table of Contents
