Table of Contents
Advertisement
General Installation Process
The installation instructions in this section are for general components of Intel® Server System
P4000RP family.
Minimum Hardware Requirements
To avoid integration difficulties and possible damage to your system,
make sure you have components from each category below.
I Processor
I Heat Sink
I Memory
I Hard Disk Drives
I Power
2
Remove the Side Cover
A
Remove the screws.
B
Slide the side cover back and lift the cover outward to remove it.
NOTE:
A non-skid surface or a stop behind the chassis may be needed to prevent the
chassis from sliding on your work surface.
3
Install the Processor
Cautions:
When removing the protective
cover, DO NOT TOUCH the
A
gold socket pins.
To avoid damage, DO NOT
DROP the cover onto the
B
socket pins or components.
When unpacking a processor,
hold by the edges only to avoid
C
touching the gold contact pins.
1
Preparing the System
Observe normal ESD (Electrostatic Discharge) procedures.
Place your Intel
surface to perform the following integration procedures.
Observe ESD procedures before reaching inside to make
server board connections or install components.
A. Open the Socket Lever
A
Push the lever
A
handle
down
and away
from the socket
to release it.
B
Rotate the lever
open all the way.
3
®
Server System on a flat anti-static
A
A
B. Open the Load Plate
Open the load
plate as shown.
C. Unpack the Processor
B
Carefully remove
protective cover
as shown.
Save the
protective
cover.
Advertisement
Table of Contents
