General Installation Process
11
Install Intel® Remote Management Module 4 NIC (optional)
A
Attach the metal fastening bracket to Intel
secure the bracket with two screws.
B
Remove the alternate RMM4 knock out by pressing the knock out from inside the chassis.
CAUTION: Carefully remove the knock out with screwdriver, directly removing it with finger has potential risk.
C
Connect the cable to the cable connector on the Intel
D
Mount the NIC module to the rear panel of the chassis and secure the bracket with two screws.
E
Connect the cable to the RMM4 NIC connector to the RMM4 NIC connector on your server board.
CAUTION: Care should be used when attaching or removing this cable. Mishandling the cable could cause damage.
12
Install RMM4 EMI Cover (optional)
A
Install the RMM4 EMI cover with
thumb screws.
B
A
®
Dedicated Server Management NIC module and
®
Dedicated Server Management NIC module.
D
Chassis
Back
Opening
B
Filler
13
Install Alternate Serial Port (optional)
Filler
C
A
Remove the alternate serial port knockout by
pressing the knockout from inside the chassis.
CAUTION: Carefully remove the knock out with screwdriver,
directly removing it with finger has potential risk.
B
Mount the serial serial port on the rear panel of the chassis.
C
secure the port with two screws.
D
Connect the cable to the Serial B Connector on your server board.
CAUTION: Care should be used when attaching or removing
this cable. Mishandling the cable could cause damage.
9
Server
Board
S e r v e
r
B o a r d
C
E
A
Chassis
Back
Opening
A
B
S e r v e
B o a r d
S e r i a
l B
C o n n
e c t o r
D
r