Install Hard Drive - Intel P4304SC2SFEN User Manual

General Installation Process
9

Install Hard Drive

Fixed Hard Drive Carrier (For chassis with fixed hard drive bay only)
A. Remove the EMI B. Install the Hard Disk Drive
shield
B
A
A
Press the clip.
B
Lift the EMI shield and
move EMI shield outward
from the chassis.
Install Hard Drive ... Continued
3.5" Hot-Swap Hard Drive Carrier (For system with 3.5" hot-swap hard drive bay only)
A
B
A
Open the Hot-swap door and
remove the drive carrier by
pressing the green button and
opening the lever.
B
Slide the carrier out.
A
A
B
Pull out the HDD Secure the 3.5" or 2.5"
carrier tray.
HDD on the HDD carrier
tray with screws.
C
C
Remove the four screws securing the
HDD interface bracket and remove the
HDD interface bracket.
B C
C
Insert the HDD carrier
tray into chassis.
D Install the hard disk drive using the
same four screws as shown. Make
sure the connector end of the drive
matches the backplane connector.
CAUTION: If you don't install all
drives, empty drive bays must
be occupied by carriers with
plastic drive blank provided to maintain
proper system cooling.
6
C. Install the EMI shield
A
A
B
C
A
Fit the edges of the EMI Shield against
the sides of the chassis.
B
Press the clip.
C
Slide the EMI Shield downwards until
the latches on the EMI Shield are
engaged with the chassis.
D
F
E
E
With the lever open, insert the
hard disk drive assembly into the
cage opening and push until the
locking lever engaged.
F
Push in the lever to lock it into
place, then close the door.