Installation Preparation; Codes; Items Required For Installation; Packing List - HearthStone Bristol DX Owner's Manual

Gas-fired direct-vent heater
Hide thumbs Also See for Bristol DX:
Table of Contents

Advertisement

Hearthstone Quality Home Heating Products, Inc.

Codes

Adhere to all local codes or, in their absence, the
latest edition of THE NATIONAL FUEL GAS CODE
ANSI Z223.1 (NFPA 54) or CAN/CGA B149 (Installer
l'appareil selon les codes ou règlements locaux, ou,
en l'absence de tels règlements, selon les Codes
d'installation CAN/CGA-B149.)
Installation Codes can be obtained from:
AMERICAN NATIONAL STANDARDS
INSTITUTE, INC.
1430 BROADWAY
NEW YORK, NY 10018
www.ansi.org
NATIONAL FIRE PROTECTION ASSOCIATION,
INC.
BATTERY MARCH PARK
QUINCY, MA 02269
www.nfpa.org
The appliance when installed must be electrically
connected and grounded in accordance with local
codes or, in the absence of local codes, with the
current NFPA 70-National Electrical Code or CSA
C22.1-Canadian Electric Code.
A manufactured home (mobile) OEM installation must
conform to the Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280 (U.S.) or
Standard
for
Manufactured
ANSI/NCBCS A225.1 or Standard for Gas Equipped
Recreational Vehicles and mobile Housing, CSA
Z240.4.CAN/SCA Z240 MH (Canada). (Installer
l'appareil selon les codes ou règlements locaux, ou,
en l'absence de tels règlements, selon les Codes
d'installation CAN/CGA-B149.)
This appliance is equipped for use at 0 to 2000 feet
(0-610 meters) altitude. (Cet appareil est equipè pour
des altitudes compries entre 0 et 2000 pieds (0-610
m) seulement.)
WARNING: DO NOT INSTALL OR USE THIS
APPLIANCE IF ANY PART WAS SUBMERGED
UNDER
WATER.
QUALIFIED SERVICE TECHNICIAN TO INSPECT
THE HEATER AND TO REPLACE ANY PART OF
THE CONTROL SYSTEM AND GAS CONTROL
THAT WAS UNDER WATER. (NE PAS SE SERVIR
DE CET APPAREIL S'IL A ÉTÉ PLONGÉ DANS
L'EAU,
COMPLÈTEMENT
APPELER
UN
TECHNICIEN
INSPECTOR L'APPAREIL ET REMPLACER TOUTE
PARTIE DU SYSTÈME DE CONTRÔLE ET TOUTE
COMMANDE QUI ONT ÉTÉ PLONGÉS DANS
L'LAU)

Installation Preparation

Home
Installation,
IMMEDIATELY
CALL
OU
EN
PARTIE.
QUALIFIÉ
POUR

Items Required for Installation

Approved venting
External regulator (for propane (LP) only)
LP conversion kit (not included, for propane
only))
Piping which complies with local codes
Pipe sealant approved for use with
propane (LP) (resistant to sulfur compounds).
Manual shutoff valve
Sediment trap (see page 26)
120 volt electrical service
Pipe wrench
Phillips head screwdriver
7/16-inch wrench
3/16" hex wrench
Other parts as required by local code
Safety Glasses
Gloves

Packing List

1- Bristol DX 8762 Gas-Fired Heater
1- Owner's Packet Envelope (manual, warranty card)
5- Decorative Ceramic Logs (in box on pallet)
1- Blower Assembly (on Stove)
4- ¼ x 20 x 1" Leg leveling screws
1- Accessory Box (on pallet) containing:
1- Remote Control w/batteries
1- Package of four AA Batteries
1- Bag of Platinum Bright Embers
1- Enamel Touch-up Paint (if applicable)
2- Orifice Gaskets and Instructions
Note: Vent kits and components are supplied
separately.
components approved by Hearthstone for this
appliance will void your warranty.

Unpacking and Inspection

Hearthstone packages your Bristol to withstand
normal shipment without damage. However, damage
can still occur during transit. Take care to inspect for
A
damage when unpacking and installing the unit.
DO NOT INSTALL, OR PUT INTO SERVICE, A
DAMAGED OR INCOMPLETE HEATER.
Remove the shrink-wrap and other packaging
materials taking care not to damage the stove's
finish. Inspect the Bristol for visible or concealed
damage. The unit should be square and true. Any
sheet metal parts should be smooth and free of
bends and dents. Any enameled cast iron should be
free of chips or cracks. If visible or concealed
13
Bristol DX Model 8762
Failure
to
use
the
venting

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bristol dx 8762

Table of Contents