Proflame Control System & Features; Bristol Dx 8762 Model Overview - HearthStone Bristol DX Owner's Manual

Hearthstone Quality Home Heating Products, Inc.
Proflame 2 Control System & Features
NOTE: OPEN DOOR UNDER THE ASH LIP AND DROP DOWN THE MODESTY PANEL FOR ACCESS TO

Bristol DX 8762 Model Overview

Proflame 2 GTMFS System
The Proflame 2 GTMFS is a modular remote control
system that directs the functions of the Bristol. The
Proflame 2 GTMFS System is configured to control
the on/off, main/split burner operation, its flame
levels, and provides Manual and Smart thermostatic
control of the hearth appliance. The system controls
two remotely actuated 120V/60Hz power outlets. The
Fan outlet controls the fan speed through six levels,
and the Auxiliary outlet either on or off. There is also
an additional constantly powered 120V/60Hz outlet.
The system has battery backup power for burner
operation and control during power outages (see
page 9 for specifications).
Figure 1 - Proflame 2 Remote Transmitter
Remote Transmitter
The Bristol comes equipped with a thermostatic
remote control transmitter. The easy to read LCD
display shows all functional abilities as well as a
childproof lockout and low battery indicator. It
displays room temperature readout, set temperature
readout and function status. The remote transmitter is
powered by three 1.5 volt AAA batteries. A Mode Key
is provided to index between the features and a
Thermostat Key is used to turn on/off or index
through thermostat functions.
ELECTRICAL AND GAS CONNECTIONS.
Back-up Battery Holder- On/Remote/Off
Switch
The back-up battery holder is powered (6V DC) by
the Control Board and uses four 1.5 volt AA type
batteries for backup during power outages. The slider
switch is set to one of three positions: ON (Manual
Override), REMOTE (Remote Control) or OFF. The
ON selection turns the valve on (to high), and
activates the split flow setting last used if the Remote
becomes inoperative.
Figure 3 – Proflame 2 Fan Control Module
Proflame 2 Control Board
This is the command center for the appliance. The
Control Board allows the pilot to run in the
Intermittent (IPI) mode or the Constant (CPI) mode.
The pilot mode can be toggled between IPI and CPI
via the remote control. The Control Board signals the
burner to light or shut down and provides the ignitor
with the electricity needed for sparking. It is the main
power supply for the entire system when 120V power
8
Bristol DX Model 8762
Figure 2 – Proflame Receiver