Yamaha TZR50 '03 Service Manual page 171

FRONT FORK
NOTE:
• When putting the fork back on, make sure
that you replace the following items with new
ones.
• Guide bush
• Oil seal
• Dust protection seal
• Make sure that all the components are clean
before installing these again.
1. Install:
• The fork spring
• The damper rod
Let the rod slide slowly along the tube
until it comes out of the bottom.
• Tapered spindle
Install the tapered spindle over the dam-
per rod coming out at the end of the
inner tube.
2. Install:
• The inner tube in the cylinder (outer tube)
3. Tighten:
• The screw (damping pipe)
Use the fixing tool
to lock the damper rod.
"T" tool :
90890 - 01326
Fixing tool:
90890 - 01294
Screw (damper rod):
2.4 kg • m
LOCTITE
7-25
CHAS
and the "T" tool
®