Yamaha TZR50 '03 Service Manual page 158

◗
w
k a
7-12
FRONT BRAKE
2. Measure:
• The thickness (a) of the pads:
If this does not match the value specified
replace
NOTE:
• Replace the pads as a set, if you find that
any of them is worn beyond the limit.
Wear limit:
0.5 mm
3. Firmly connect a suitable tube 1 to the
caliper bleeding screw. Then insert the
other end of the tube into an open reci-
pient.
4. Unscrew the bleed screw of the caliper
and press the piston with your finger to
make it go into this.
5. Tighten:
• The caliper bleeding screw
Caliper bleeding screw:
0.5 m • kg
6. Assembly:
• The brake pads (new)
• The retaining screw
• The retaining pin
CHAS