Main Menu - Printronix N7000 H-Series User Manual

Main Menu

Brief descriptions follow for the first-level configuration menu options:
•
•
•
•
•
•
•
•
•
•
•
QUICK SETUP — These options allow quick access to the most
frequently changed or inputted parameters during the installation of the
printer.
ZTP SETTINGS These options allow you to set parameters for zero tear
pedestal printers.
CONFIG. CONTROL — These options allow you to save, print, load,
delete, name, and reset entire sets of configuration parameters.
HOST INTERFACE — These options allow you to select either the Serial
RS-232, Serial RS-422, Centronics
™
Long Lines, Ethernet , IEEE
printer. This menu also allows you to configure several parameters for
each interface.
NETWORK SETUP — This option allows you to select from Ethernet
Address options and Ethernet Parameters options.
ACTIVE (IGP) EMUL — This menu allows you to select the PGL or VGL
emulation from the menu if IGP is installed.
EMULATION — This menu allows you to configure the options which are
available for the current operating (active) emulation. For example, if
LinePrinter+ is the active emulation, then the LinePrinter+ emulation
options can be configured using this menu.
PRINTER CONTROL — This menu allows you to select parameters
common to a general user, such as display language and Barcode
quality.
ADVANCED USER — This menu allows you to select several advanced
operating parameters for the printer, such as the speed at which paper
will advance when slewing.
DIAGNOSTICS — This menu includes the diagnostic tests, system
memory, software build part number, Feature File (if one exists),
the shuttle type, and statistics of the printer.
PRINTER MGMT – These options allow you to select the PNE port type,
port number, port timeout period, status port number, and management
port number.
®
parallel, Dataproducts
®
1284 parallel, or Auto Switching for the
®
parallel and
57