Table of Contents
Advertisement
Vertical Position
Knob
Platen
Stop
Platen Lever
183444 REV B
Figure 15. Adjusting the Platen Lever
28. Turn the platen stop knob clockwise or counterclockwise to match the
paper thickness. (The A-B-C scale corresponds approximately to 1-, 3-,
and 6-part paper thickness. Adjust until you have the desired print
quality).
NOTE: The platen stop allows you to set an optimum and consistent
thickness that is not affected when opening and closing the platen
lever.
29. Lower the platen lever until it stops.
30. Press ON LINE/CLEAR to clear any fault messages (such as "LOAD
PAPER") from the LCD.
31. Press SET TOF. The top-of-form you have set moves down to the print
position. If there is data in the buffer, the paper moves forward to the last
print position on the next page.
32. Press ON LINE/CLEAR and close the printer cover.
A
Reload Paper
Paper Thickness
Indicator
A
Platen Stop
Knob
35
Advertisement
Table of Contents
