Printronix N7000 H-Series User Manual page 217

Table 13. N7000 H-Series Fault Messages Troubleshooting
Displayed Message
D50 Status %XX No
Clearing Flash
D51 Status %XX No
Programming...
D55 Status: Send No
Program to EC
DIAGNOSTIC No
PASSED
DO NOT POWER OFF No
E00 EXE @ ADDR0 Yes
See User Manual
E01A TYPE 0x40 Yes
See User Manual
Can User
Explanation
Correct?
Status message: The printer
is clearing its flash memory,
where %XX represents the
percentage completed.
Status message: The printer
is loading firmware, where
%XX represents the
percentage completed.
Status message: The printer
is loading the engine
controller program into the
engine controller (EC).
Status message: the printer
passed its memory and
hardware initialization tests.
Status message: The printer
is performing an operation
that must be completed
before you can cycle power.
An illegal or unsupported
instruction was attempted in
the application program.
An illegal or unsupported
instruction was attempted in
the application program.
N7000 H-Series Printers Fault Messages
Solution
No action is required.
No action is required.
No action is required.
No action is required.
No action is required, but do not
power off the printer until the
operation is complete.
1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
217