Printronix N7000 H-Series User Manual page 205

Table 12. N7000 STD ASCII LCD Fault Messages Troubleshooting
Displayed Message
WELD RESET ERROR No
See User Manual
WELD SNSR MISSING Yes
See User Manual
1
Before contacting an authorized service representative, power off the printer, wait 15 seconds, then
power it back on and rerun your print job. If the message reappears, press CLEAR. If the fault message still
displays, then contact your authorized service representative.
Can User
Explanation
Correct?
The cartridge weld
circuitry lost power.
Weld sensor cannot be
detected by the system.
N7000 STD ASCII Printers Fault Messages
Solution
Contact your authorized service
representative.
1. Make sure that weld sensor is
installed correctly.
2.
Contact your authorized
service representative.
1
1
205