Pump Priming - Emerald Spa Lite Leader Owner's Manual

40
Emerald Whirlpool Spa Owner's Manual
Two-Pump Priming
[for spas equipped
with DS-2 and DS-4]
Note:
If water does not flow within a
minute or two, turn off all power
to the spa and repeat steps for
bleeding air.
Caution:
Never run the system without circulating water! Doing so can damage pumps and void the warranty.
Each pump must be primed separately. To accomplish this, follow these steps.
1. Press the "Jets" key pad twice. The circulating/jets pump will operate in the low speed mode on the
first press and in the high speed mode on the second press. The high speed mode will facilitate

pump priming.

2. When the jets begin to operate moderately, the circulating/jets pump is completely primed.
3. Now press the "Jets" key pad a third time. The jets booster pump will now operate.
4. When the jets begin to operate more vigorously, the jets booster pump is completely primed. If you
do not see any distinguishing difference in jet flow when pressing the "Jets" button a third time then
the booster pump may require direct priming.
A. Remove the equipment panel and locate the booster pump (see 2-pump system diagram on
page 16).
B. With the booster pump running turn the pump drain plug counterclockwise until a steady
stream of water appears. Once water appears quickly tighten the plug and you should
notice a more intence flow of water through the jets.
C. If no noticeable difference has occured repeat step B.
Water Line Connection goes to the jet