Emerald Spa Lite Leader Owner's Manual page 23

22
Emerald Whirlpool Spa Owner's Manual
Spa Side Control
Panel SS-3D
Start-Up
Your spa control has been specifically designed so that by simply connecting the spa to its properly
grounded source, the spa will automatically heat to the set temperature.
o o
Temperature Adjustment (60 F - 104 F)
Spa temperature is controlled by pressing the "Set" pad. The display shows the actual water temperature
unless the pad is pressed. When the pad is pressed, the display will show the set temperature. Pressing the
pad a second time will cause the set temperature to increase or decrease depending on what direction was
last chosen. Each successive press will change the set temperature in the same direction.
If the opposite direction is desired, release the pad and let the display revert to the actual water tempera-
ture again. Press the pad to display the set temperature, and again to make the temperature change in the
desired direction.
Jets Keypad
Touch the "Jets" pad once to activate the low speed pump. Touch the pad again to activate the high-speed
pump. Press the pad a third time to deactivate the pump. The low-speed pump starts automatically when
the heater is turned on, when a filter cycle is activated, or when a freezing condition is detected. If auto-
matically activated, the low-speed pump cannot be disabled from the front panel; however, the high-speed
pump may be started. Whenever the low-speed pump is energized with this pad, it will automatically turn
off after 2 hours. The high-speed pump turns off after 15 minutes.
Air Keypad
Press the "Blower" pad to turn the air jets on and off. The air jets will automatically turn off after 15 min-
utes of use.
Light Keypad
Press the "Light" pad to turn the spa light on and off. The spa light will automatically turn off after 1 hour.