Testing The Ground Fault Circuit Interrupter (Gfci); Pump Priming - Emerald Spa Lite Leader Owner's Manual

Testing the GFCI
[for spas equipped
with Lite Leader (240V)
SS-1D, SS-3D, DS-2,
and DS-4]
One pump Priming
[for spas equipped
with Lite Leader,
SS-1D, and SS-3D]
Note:
If water does not flow within
a minute or two, turn off
power to the spa and repeat
steps for bleeding the air.
Your spa must be provided with a GFCI-circuit breaker located in the power supply panel as installed by
your electrician. Turn on the circuit breaker and test the GFCI by pushing the test button. A red indicator
should appear and your spa should stop operating. Push the reset button and the red indicator should
disappear. The spa should begin to operate normally.
WARNING:
If the GFCI fails to operate in this manner, there is a risk of electric shock! Shut off the main power source.
Identify and correct problem before using the spa.
Caution:
Never run the system without circulating water. Doing so can damage the pump and void the warranty.
1. Press the "Jets" key pad. The pump will begin to operate in the high-speed mode; this will
facilitate pump priming.
2. When your jets begin to operate vigorously, the pump is primed.
39
Starting and Using Your Spa