Emerald Spa Lite Leader Owner's Manual page 31

30
Emerald Whirlpool Spa Owner's Manual
Spa Side Control
Panel DS-4
(continued)
Programming
Initial Start-up
Your Spa Control has been specifically designed so that by simply connecting the spa to its properly
grounded source and touching the Mode [#] pad, the spa will function properly and safely at 100
mode, all user pads will be completely functional. The spa will just about take care of itself. However, to
fully utilize the unique capabilities of the control, it is important to set the time of day and the day of the
week properly.
Setting the Time
Once the spa has been properly connected, notice the "SET TIME" message flashing on the screen.
PRESS THEN
OR After either pad is pressed once, hours will advance or decrease automatically in
one-minute increments. Press either pad again to stop the display's time-setting cycle.
Panel Lock
To help prevent unauthorized use of your spa, the Cygnus control has incorporated a unique panel locking
system. When the panel lock is engaged, all automatic spa functions will operate normally.
To lock the panel
These pads must be pressed in the correct sequence and within 3 seconds to activate the lock. When locked,
the center display will show the spa temperature along with the lock symbol. All the pads are now
deactivated except the program pad, which is used to initiate the unlock sequence.
PRESS
THEN
THEN
THEN
THE CENTER DISPLAY WILL READ
o F. In this