Lite Leader - Emerald Spa Lite Leader Owner's Manual

18
Emerald Whirlpool Spa Owner's Manual
Spa Side Control

Lite Leader

Start-up
Your Lite Leader control has been specifically designed so that by simply connecting the spa to its properly
grounded source, the control will automatically heat the water to the set temperature. Your spa equipped
with the Lite Leader is shipped in the 240V configuration. See the Lite Leader schematics on page 53 if you
plan to convert the Lite Leader power system to a 120V configuration.
Temperature Adjustment (80 o F - 104 o F)
Temperature adjustment is controlled by pushing the pad. The display shows the actual water tem-
perature unless the pad is pressed. When the pad is pressed, the display will show the set temperature.
Pressing the pad a second time will cause the set temperature to increase or decrease depending on what
direction was last chosen. Each successive press will change the set temperature in the same direction.
If the opposite direction is desired, release the pad and let the display revert to the actual water tempera-
ture again. Press the pad to display the set temperature, and again to make the temperature change in the
desired direction.
Light and Jets Keypad
Press the pad once to turn on the light. Press the pad again and the low-speed pump, light and ozone
generator (if installed) will operate. Press the pad a third time and the high-speed pump and light will run.
Press the pad again and only the high-speed pump will be on. Press the pad a final time to turn off all
functions. The light will automatically turn off after 4 hours of operation. The low-speed pump and ozone
generator (if installed) turn off after 2 hours, and the high-speed pump turns off after 15 minutes of opera-
tion. The low-speed pump starts automatically when the heater is turned on. If automatically activated, the
low-speed pump cannot be turned off with the function pad; however, the high-speed pump may be
started.