Emerald Spa Lite Leader Owner's Manual page 29

28
Emerald Whirlpool Spa Owner's Manual
Spa Side Control
Panel DS-4
(continued)
Light Keypad
Press this pad to operate the light cycle. The light will automatically turn off after 1 hour of
operation. If your spa is equipped with optional fiber optic lighting, then 4 colors will cycle
once you press the light keypad. To stop on a desireable color press the light keypad a
second time. To turn the fiber optic lighting off press a third time.
Time
Press this pad to view time of day and press again to view temperature. Current spa
temperature display will automatically resume after 3 seconds.
2. Liquid Crystal Display
This display continually shows operating status of the spa, as well as the various
monitoring functions and programing information.
3. User's Program Keypads
Program function
This pad initiates time setting, 7-day programming, 24-hour pump operation and panel lock
routines.
Mode function
Press this pad to switch spa operation to either the Economy or Standard mode. When the
Economy mode is selected, the heater will maintain a temperature of 20
temperature. In the Standard mode, the preset spa temperature will be maintained. This
pad also resets the control in the event of an overheat display message (see Center Display Messages).
Automatic Operations
Preset Filter Cycles
Your spa filter cycles are pre-programmed from the factory to automatically filter for a 3-hour period every
12 hours. The first filter cycle is automatically activated at 2:00 AM and runs till 5:00 AM. The second cycle
is between 2:00 PM and 5:00 PM. During these cycles the heater will operate in the economy mode.
o F below the preset