Spa Side Control Panels - Emerald Spa Lite Leader Owner's Manual

Spa Side Control
Panel DS-4
Start-up
When your spa is powered up, it begins running in standard mode, which automatically heats and main-
o
tains the water at 100 F. Pressing the # pad switches the spa from standard mode to economy mode. This
setting is designed for periods of little or no use, but continues to filter twice a day and maintains water
quality
General Description
Your Control panel consists of three main parts:
User's Keypads
1.
Temperature Controls (60
When either of these pads is touched once, the LCD will display the temperature
which has been set, as well as the words "SET HEAT". Each time either of these
pads is pressed again, the set temperature will increase or decrease, depending on
which pad is pressed. After 3 seconds, the LCD will automatically display the spa temperature.
Jets Keypad
Touch this pad once to activate the low-speed pump. Touch again to activate the high-
speed. Press the pad a third time and the second pump will also activate. Press the pad
again to deactivate the pump(s). The low-speed pump starts automatically when the heater
is turned on, when a filter cycle is activated, or when a freezing condition is detected. If automatically
activated, the low-speed pump cannot be turned off with the "jets" pad; however, the high-speed pump may
be started. When the low-speed pump is started with this pad, it will automatically stop after 2 hours and
20 minutes of operation. The high-speed pump will stop after 15 minutes.
Blower Keypad
Touch the blower keypad to activate the first speed of the blower (high). Press the pad
again to activate the second speed of the blower (low) and once again to turn the blower off.
The blower will automatically turn off after 15 minutes.
o o
F - 104 F)
27
Features and Controls