Preparing Milk Foam (Siena 2); Milk Foam Quality (Installing The Milk Nozzle); Pre-Heating Cups; Grinder Settings - Schaerer Siena 1/2 User Manual

www.schaerer.com
50

Preparing milk foam (Siena 2)

Milk foam can be dispensed and/or added at any time.
► Place a cup under the outlet.
► Press the button and keep it pressed.
► Press and hold the cappuccino/macchiato button to dispense milk foam. „Milk" appears on
the display.
► The dispensing procedure is stopped by releasing the cappuccino/macchiato button.
► Remove the cup from under the outlet.

Milk foam quality (installing the milk nozzle)

Depending on the milk and milk temperature used, (see Chapter „Safety notes" ► „Hygiene" on
page 41), the milk foam quality can be controlled using the milk nozzles provided. They feature
different dispensing diameters (diam.).
► Insert the milk nozzle into the milk tube as far as it will go (refer to the picture). Without the milk
nozzle, the milk tube can become stuck to the bottom of the container.
Adjusting milk foam:
► Milk foam too cold:
► Milk foam too hot:

Pre-heating cups

This is recommended for smaller quantities of coffee (espresso). In addition to the coffee mixture
used and the water quality, the right temperature is important for making good coffee.
There are two ways to pre-heat cups:
► Place cups on the hot plate for cups (refer to the picture).
► Rinse cup with hot water by using the hot water nozzle. (Refer to page 49/50, „Preparing hot
water").

Grinder settings

The grinder comes with a default setting that processes most coffee beans optimally.
The grinder setting may only be adjusted while the grinder is in operation.
► Using the multi-tool adjusting knob (included in the scope of delivery), adjust the grinder setting
to the desired position (see below):
• Grinder setting 1 = fine / turn clockwise
• Grinder setting 6 = coarse / turn anti-clockwise
• Default setting = grinder setting 3-4 (intermediate grinding)!
When coffee is finely ground, brewing times are increased (the coffee becomes stronger), and
the volume of foam increases.
fit a smaller diameter (milk nozzle).
fit a larger diameter (milk nozzle).
Operation
BASI 2 - EN
Version 04
08.2007