Outgoing Authentication Protocol; Remote Node Setup; Figure 4-3 Remote Node Network Layer Options - ZyXEL Communications Prestige 650H-17 User Manual

Prestige 650H-17 ADSL Router

4.1.3 Outgoing Authentication Protocol

For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendors' implementation includes specific authentication protocol in the user profile. It will disconnect if
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.
4.2

Remote Node Setup

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
IP Options:
Press ENTER to Confirm or ESC to Cancel:
The next table explains fields in Menu 11.3
4-6
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= None
Multicast= None
IP Policies=

Figure 4-3 Remote Node Network Layer Options

–
Bridge Options:
Ethernet Addr Timeout (min)= N/A
Remote Node Network Layer Options.
Remote Node Configuration