Printing Your First Creation - 3D Systems Cube User Manual

PRINTING YOUR FIRST CREATION

PRINTING FROM THE USB MEMORY STICK
1. If you are using your USB Memory Stick to download your Cube file, please install the USB Memory Stick into the
USB port on your computer. Open the file folder where your Cube file is located and save it on the USB Memory Stick.
Remove memory stick and install it into the Cube's USB port .
Print
2. Tap on the touchscreen and use left or right arrows until you see your Cube file displayed.
3. Tap on your .cube file; the print touchscreen will
appear showing the total time it will take to print
your creation and the time left to complete it during
printing . It also shows the maximum height of your
creation and the current height while printing .
4. The Cube will begin the heating process that
will take a few minutes . During the heating
process, the print tip and the Print Pad will reach
the temperatures that have been preset by the
manufacturer . Once these temperatures are
reached, your creation will begin to print . Once the
creation is finished printing, your touch screen will
Print Finished
display
confirm. Wait until the Print Pad is completely cool
before removing your print .
WARNING: PRINT JET NOZZLE TIP BECOMES EXTREMELY HOT DURING SET-UP AND OPERATION. DO
!
NOT TOUCH NOZZLE.
Do not change color of material or cartridge during printing; doing so may damage the Cube.
ABORTING YOUR PRINT
To abort your creation during warm up or printing, finger tap the
you sure you want to abort the print?
tip completely cools before touching .
(continued)
, press the check box to
Finger tap the check box to abort or tap the X box to cancel . Wait until the print
STOP
button on touchscreen . The next screen will read
25
Are