Unpacking And Setting Up Your Cube - 3D Systems Cube User Manual

6

UNPACKING AND SETTING UP YOUR CUBE

The Cube Material Cartridge*
Power Supply
Quick Start Guide
*Neon green included **For downloading firmware
SETTING UP YOUR CUBE
1. Remove the white plastic inserts from each side of the box by pinching the tabs in and bending the inserts out . Pull to
remove both from the box . Lift top of carton up and remove .
2. Lift foam from the top of Cube . Remove foam from the midsection and below the plate by gently pulling out from the
front . Remove Cube from box .
3. Lift foam that Cube was sitting on to access power supply and other accessories .
4. Remove the Print Pad from the foam under the Cube and set it aside .
5. Plug round connector of power supply into the back of the Cube .
6. Plug power cord into power supply, then into outlet or power strip .
Print Pad
Power Cord USB Cable**
***For unclogging filament in Print Jet
CubeStick™
Unclog Tool***
14
Cube Tube
USB Stick