Wi-Fi Set-Up; Non-Wireless Computer Set-Up (Without Wi-Fi Options); Update Cube Firmware - 3D Systems Cube User Manual

SWITCHING FROM AD-HOC TO WLAN CONNECTION (OR VICE VERSA)
1. Close out Cube Software .
2. Disconnect the Cube's wireless connection through the Internet Access menu on your operating system .
3. Now follow steps for WLAN / ad-hoc set up .
4. Re-open your software after your Cube successfully connects to WLAN / ad-hoc .
NON-WIRELESS COMPUTER SETUP
14
If you are not connected to a network, you can download your creations from your computer and save them to your USB
Memory Stick for printing .
• When printing with the USB Memory Stick, the file must be in the main folder
located on the memory stick . If it is put into another folder it cannot be accessed
from Cube screen .
• Install your USB Memory Stick into your computer's USB connection and save your
creation to your USB Memory Stick .
• When you are ready to print your creation, install your memory stick into the Cube's
USB connection and print your creations .
15

UPDATE CUBE FIRMWARE

1. Tap on Setup on the Cube touch screen and scroll to
2.
If your USB Memory Stick is connected to the Cube, please remove the memory stick, (the screen will display the
directions to do this) . Tap the
port located on the back of the Cube (again, these instructions will be displayed on the screen) . Connect the other end
of cable to your computer's USB port .
NOTE: Never leave the USB cable connected except when upgrading the firmware.
3. Tap the NEXT arrow .
displayed at the top of the screen . You will have 6
seconds to press and hold the control button until
firmware loader appears on the screen. If the button
is released before the firmware screen appears, the
screen will go blank . Repeat Step 1 to restart the
update firmware process.
4. Continue to hold button until
then Cube Firmware Loader
screen . You are now in the correct mode to update
your firmware. NOTE: Even though the update is
unsuccessful, WLAN WI-FI should still work, To
try again, simply reconnect to the network,
5. Open Cubify Software and click the
icon; click on Load New Cube
you see the pop-up message
Successfully, click OK .
6. Disconnect the USB cable from your Cube and computer; unplug the Cube power cord . Plug power cord back in and
press the Cube power button; a message will display on the touchscreen "Setting restored," click on the check mark to
save settings. This does not change your previous settings that you have made. Your new firmware is now installed.
NEXT arrow on the display; locate the USB cable and connect the cable to the Cube USB
SETTINGS SAVED will be
Settings Saved and
appears on the touch
Configure
Firmware . Once
Firmware Updated
Update Firmware .