Cloud Printing From Cubify .Com; Finishing Your Creation - 3D Systems Cube User Manual

21 CLOUD PRINTING FORM CUBIFY.COM
1. My Cubify
Click on and select
My Downloads
2. Click on
3. If you would like to download a file to save on your computer or print using Cube software, click on
file will download to the Cube software on your computer to save your creation.
4. Your file can download directly to your Cube by clicking on
appear and will search for available Cube printers on your network .
5. If a Cube was not discovered in your network, you can either save the .cube file to your computer or connect through an
ad hoc network (refer to PRINTING WITH WI-FI CONNECTION, page 25) .
6. If a Cube is discovered in your network, you have a choice of printing now or decline printing . If you select print now,
your print will start printing on the Cube you selected in the network .
22 FINISHING FIRST CREATION
REMOVING YOUR CREATION FROM THE PRINT PAD
• Place the Print Pad with your creation in a container (not supplied) filled with regular
warm tap water and let it soak approximately five minutes or until your creation
eases free from the Print Pad . Clean and dry the Print Pad before reuse .
• To clean your Print Pad, rinse under tap water and dry with a lint-free wipe .
REMOVING RAFTS AND SUPPORTS (IF REQUIRED)
• Use small pliers to remove supports and rafts . In places where the supports are
inside your creation and are hard to get to, use small wire snips (not provided) to
remove the supports .
My Account
.
.
PRINT ON MY CUBE
; the Select Cube Printer screen will
27
DOWNLOAD
. The