Steps For Printing Your First Print; Check/Add Material In Mdm; Before Starting Print - 3D Systems projet mjp 2500 User Manual

STEPS FOR PRINTING YOUR FIRST PRINT

Once the printer is powered up, allow time for the printer to warm up and the materials in the MDM (Material Delivery Drawer) to heat up before accessing the
drawer and inserting cartridges. If no cartridges are installed, or cartridges are installed but cold, it can take 20 minutes before the material deliver system is
warm enough to insert or remove cartridges. The status screen will display the Material Drawer is locked until the cartridges are available to access.
While the printer is warming up, the Printer State will alternate between
completely cold system) while warming and doing print head maintenance.
The status screen will display the
Once the system is warm and the material has melted to room temperature, the printer will automatically perform several
arriving at a Ready state.

Check/Add Material in MDM

You can check the material levels by selecting the
in the printer is used. If you need to change material you will need to run a
found in the Cleaning and Maintenance

Before Starting Print

Perform a Jet Check Procedure to confirm that all the jets are working properly prior to printing your first build or anytime you notice print quality issues. See
Confirm Jets section of this manual for procedure.
Every time a job is sent to print, the UI will ask the user to confirm that a clean print platform is installed. UI will also ask the user to confirm the waste bag level.
Ensure that the print platform is clean and free from defects. Printing with a dirty or damaged platform can cause severe damage to the printer.
1. Select Access Platform from the UI.
2. Inspect platform to ensure it is clean and free from defects.
NOTE: Using a dirty or damaged platform can cause severe damage to printer. Always make sure your platform is clean and free from
defects.
3. Install platform back into printer.
4. Next select Tools > Waste Bag
Warmup Time Remaining, once the cartridges are inserted.
Materials tab. If material is required to print the next build make sure that the same material that is currently
section.
(1).
"Warming" and "Busy" states for up to 1 hour, 15 minutes (time to warm up from a
Material Changeover using the
Head Maintenance Cycles
Material Change Wizard. Instructions for this are
before