Command Description; System Commands - SignaMax 065-7942 User Manual

Signamax Connectivity Systems __________________________________________

Command Description

These are the group commands of the command line interface:
Command groups:
System
Console
Port
VLAN
Aggr
QoS
Mirror
IP
SNMP
Ratelimit
Exit

System Commands

Commands at System level:
System Configuration [all]
System Restore Default [keepIP]
System UserName [<name>]
System Password [<password>]
System Systemname [<name>]
System Reboot
System Configuration [all]
Syntax:
System Configuration [all]
Description:
Show system name, username, password, software version and management MAC
address. Optionally show the full configuration
[all]: Show the total switch configuration (default: System configuration only)
System Restore Default [keepIP]
Description:
Restore factory default configuration.
[keepIP]: Preserve IP configuration (default: Not preserved).
UserName [<name>]
Description:
Set or show the user name.
[<name>]: String of up to 16 characters (default: Show user name).
System Password [<password>]
Description:
Set or show the console password. The empty string ("") disables the
password check.
[<password>]: Password string of up to 16 characters.
System Systemname [<name>]
Description:
- System commands
- Console commands
- Port commands
- VLAN commands
- Aggregation commands
- QoS commands
- Mirror commands
- IP commands
- SNMP commands
- Rate setup commands
- Logout commands
32
065-7942