Entering Commands; Command Description; System Commands - SignaMax 065-7932 User Manual

USER´S
MANUAL

Entering Commands

To give any command, please key in your command and press enter.
Example:
1. Type "system" and press <enter> to get access to the system command group.
2. Type "Configuration" and press <enter> to perform "configuration".
You can type "up" and press <enter> to go back to the upper level.

Command Description

These are the group commands of the command line interface:
Command groups:
System
Console
Port
VLAN
Aggr
QoS
Mirror
IP
SNMP
Ratelimit
Exit

System Commands

Commands at System level:
System Configuration [all]
System Restore Default [keepIP]
System UserName [<name>]
System Password [<password>]
System Systemname [<name>]
System Reboot
System Configuration [all]
Syntax:
System Configuration [all]
Description:
Show system name, username, password, software version and management MAC
address. Optionally show the full configuration.
[all]: Show the total switch configuration (default: System configuration only).
System Restore Default [keepIP]
Description:
Restore factory default configuration.
[keepIP]: Preserve IP configuration (default: Not preserved).
26
- System commands
- Console commands
- Port commands
- VLAN commands
- Aggregation commands
- QoS commands
- Mirror commands
- IP commands
- SNMP commands
- Rate setup commands
- Logout commands
www.signamax.eu