Table of Contents
Advertisement
2. Command Line Interface (CLI)
This chapter describes how to use your Managed Switch CLI, specifically in:
• Local Console
• Telnet
• Configuring the system
• Resetting the system
The interface and options are the same with Local Console and Telnet. The difference is
the type of connection and the port that is used to manage the Managed Switch.
2.1 Using the Local Console
Local Console is always done through the RS-232 DB-9 port and requires a direct
connection between the switch and a PC. This type of management is useful especially
when the network is down and the switch cannot be reached by any other means.
You also need the Local Console Management to setup the Switch network configuration for
the first time. You can setup the IP address and change the default configuration to desired
settings to enable Telnet or SNMP services.
Follow these steps to begin a management session using Local Console Management:
Step 1.
Attach the serial cable the RS-232 DB-9 port located at the back of the Switch
with a null modem.
Step 2.
Attach the other end to the serial port of a PC or workstation.
Step 3.
Run a terminal emulation program using the following settings:
• Emulation
• BPS
• Data bits
• Parity
• Stop bits
• Flow Control
• Enable
Step 4.
Press Enter to access the CLI (Command Line Interface) mode.
SIGNAMAX a.s.
Office: Vlarska 22, 627 00 Brno, CZ
T:+420 533 338 854 l F:+420 533 338 883 l www.signamax.eu
VT-100/ANSI compatible
9600
8
None
1
None
Terminal keys
10
Advertisement
Table of Contents
