Fuji Xerox DocuPrint CP215 Series User Manual page 156

• WPS Setup (DocuPrint CP215 w Only)
Purpose:
To configure the wireless network using WPS.
Values:
Push Btn.
Ctrl
PIN Code
NOTE:
• Instead of selecting Push Btn. Ctrl, you can also start WPS-PBC by pressing and holding the
button.
• WPS 2.0 compliant. WPS 2.0 works on access points with the following encryption types: Mixed Mode PSK,
WPA-PSK-AES, WPA2-PSK-AES, WPA-PSK-TKIP, Open (No Security)
• This item is displayed when the Ethernet cable is disconnected and Wireless LAN is set to Enable.
• Init Wireless (DocuPrint CP215 w Only)
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all
wireless network settings are reset to their factory default values.
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wireless LAN is set to Enable.
• TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
IP Mode
IPv4
NOTE:
• When you set an IP address in IPv6 mode, use the CentreWare Internet Services. For more information, refer
to the Help on the CentreWare Internet Services.
156 Using the Operator Panel Menus
Configures the wireless settings with the security method of WPS-PBC.
Configures the wireless settings using the PIN code assigned
Start
automatically by the printer.
Config.
Prints the PIN code. Confirm it when you enter the PIN code to your
Print PIN
computer.
Code
Dual Stack*
IPv4 Mode
IPv6 Mode
DHCP/AutoIP* Automatically sets the IP address.
Get IP
Address
BOOTP
RARP
DHCP
Panel
IP Address
Network Mask
Gateway Address
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Uses DHCP to set the IP address.
Enables the IP address entered on the operator
panel.
Manually sets the IP address allocated to the
printer.
Manually sets the subnet mask.
Manually sets the gateway address.
(Wi-Fi)