Usb Setup; System Setup - Fuji Xerox DocuPrint CP215 Series User Manual

USB Setup

Use the USB Setup menu to change printer settings affecting a USB port.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Port Status
Purpose:
To change the USB settings on your printer. The change becomes effective after the printer is turned
off and then on.
Values:
Disable
Enable*

System Setup

Use the System Setup menu to specify the various basic settings for the printer.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• PowerSaver Time
Purpose:
To specify the time for transition to Power Saver Mode.
Values:
Mode1
Mode2
Select 5min. (default) for Mode1 if your printer shares an electrical circuit with your room lights and
you notice them flickering. Otherwise, select a high value to keep your printer available for frequent
use with the minimum warm-up time.
The printer automatically returns to the standby mode from the Power Saver Mode when it receives
data from the computer. In Mode1, you can also return the printer to the standby mode by pressing
any button on the operator panel. In Mode2, you can return the printer to the standby mode by
pressing the (Energy Saver) button.
158 Using the Operator Panel Menus
Disables the USB interface.
Enables the USB interface.
Specifies the time taken by the printer before it enters Mode1
5min.*
after it finishes a job.
5–30min.
Specifies the time taken by the printer before it enters Mode2
6min.*
after it goes into Mode1.
1–6min.